Toyo TT-150HR2 Vertical Injection Molding Machine

Central Plastic Machinery

TT-150HR2 Specifications

• TT-55HR2

Need a Brochure?

View Brochure Directory

Injection Unit
System	1	In-line screw
Injection stroke	in	6.3
Screw diameter	in	1.57	1.81
Nominal injection capacity	in³	12.2	16.2
Injection capacity (ps)	oz	6.7	8.8
Injection rate	in³/sec	9.0	12.0
Injection pressure	psi	27,971	21,145
Recovery rate (ps)	oz/sec	0.8	1.1
Screw revolution	rpm	15~285
Nozzle pressure force	U.S.ton	2.5
Hopper capacity	gal	10.6
Screw drive system	2	Hydraulic motor
Clamping Unit
Number of stations		2 [180 reversible]
Clamping system 1		Vertically moving hydraulic system
Clamping force	U.S.ton	150
Opening force	U.S.ton	9.3
Clamping stroke	in	11.02
Min. mold height	in	9.84
Daylight	in	20.87
Table diameter	in	54.53
Ejector force	U.S.ton	4.5 [3-point ejecting]
Ejector stroke	in	2.95
Rotary table height	in	47.05
Nozzle center height	in	5.9~8.85 [from table surface]
Max. lower mold-half weight	lb	705 x 2 pce1
Others
Heater capacity	kw	8.65
Pump motor	kw	18.5
Oil tank capacity	gal	60.8
Machine dim. ( L x W x H )	in	157 x 78.5 x 92
Machine weight	U.S.ton	7.3

Notes:

*mark figure varies depending on molding conditions.
Figures in are optional.
The applicable max. injection pressure and holding pressure will be restricted according to the material in the real molding operation.
The figures for the max injection rate and the max. injection speed are calculated ones. The actual injection rate and injection speed will be restricted by pressure. Actual setting pressure may be restricted by molding conditions and cycle time.
The figures are subject to change without any legal obligation on the part of the manufacture.
A large-sized screw may not be applicable to some kinds of material.

TOP